Nilfisk-Advance America GB 1133 Uživatelský manuál

Instruction manualGB 1133Categories of application: U, S, C, B1, EOB, K1ATTENTIONKeep these instructions for future reference!

9 Adjusting the automatic gear change of the minimum airflowUse the performance profile to adjust the cutoff point for the minimumairflow of extracto

The works for configuring an extractor (connecting the cable, adjustingthe cutoff point) may only be carried out by a technician or skilledpersonnel u

GB 1133 Performance profile

10 Monitoring the airflow All Nilfisk vacuum cleaners - except category of application “U“ -are fitted with a manometer that allows you to monitor th

11 Cleaning the filterNilfisk-Advance systems are fitted with a device for cleaning the main filter. First ofall, switch the machine off. Then move t

12 Emptying the containerIndustrial vacuum cleaners with antistatic design need to be emptied afterevery single use.First of all, switch the motor of

13 Disposal of collected dustCategory of application: “U“The are no particular prescriptions, but take care that no one around you will beaffected by

Category of application: “C“ and “K1“Type B: Disposable container Art.no. 031 101When the container has been torn away from the machine, close it

14 Pre-separatorThe system can connect to secondary interceptor tanks for even greater waste capacity of 200 litres at a time. The lid fitting both s

15 Notice on K1 vacuum cleaners used for removing asbestosA vacuum cleaner that has been used for removing asbestos in a contaminated areamay no long

1 ContentsParagraph Page1 Contents 22 Scope of the instruction manual 33 Tests 44 Categories of application 55 Technical specifications 6

16 ServiceNilfisk-Advance LimitedNewmarket RoadBury St. EdmundsSuffolk IP33 3SRTel: 01284 763163Fax: 01284 750562Internet: www.nilfisk-advance.com____

2 Scope of the instruction manualThis instruction manual is valid for the the following machine types:GB 1133 – U(L)GB 1133 – C(M,H)GB 1133 – S(M) -

3 TestsAll Nilfisk-Advance systems are tested in order to comply with the requirements ofsystem safety regulations. They have fulfilled the technical

4 Categories of applicationThis Nilfisk machine is suitable for removing dusts of the following categories ofapplication:“U“ suitable for removing ha

5 Technical specificationsVoltage 400 VRated power 13,000 WVacuum 320 mbarConnection Ø 70/100 mmAirflow 750/930 m³/hFilter area Main filter (U,S,

6 General notice on safetyOnly original Nilfisk spare parts may be used.The machine may only be operated by instructed and authorised individuals.Liq

7 Filters and emptying systemsThe installed main and exhaust filters are approved by the German TradeAssociation Institute for Safety at the Workplac

8 Initial operationPlease read these notes of safety before initial operating.The application scope of the machine is marked on the rating-plate.Indu